A-FLIP Installation
The A-FLIP is a SuperSlot adapter that changes the orientation of an A10-RX in an SL-6 or A10-RACK
The instructions below describe installation of the A-FLIP adapter
Before starting please make note of the following:
Supplies Required
- A Phillips head screwdriver
- The A-FLIP uses the screws already installed in the A-SL
- Four M2.5×0.45 16mm screws
- Two M3x0.5 6mm screws
Step 1
Detach the A-SL from the A10-RX by removing the four 16MM screws from the corners. Set the screws aside for reassembly.

Step 2
Detach the A-SL from the back of the A10-RX.

Step 3
Remove the two 6mm screws from either side of the DB-25 connector. Set the screws aside for later use.

Step 4
Slide the connector out of the housing.

Step 5
Insert the A-FLIP into the A-SL housing.

Step 6
Using the two 6mm screws, secure the A-FLIP.

Note that the longer side of the connector is now facing up.

Step 7
Insert the A-SL with A-FLIP back onto the A10-RX

Use the tab to guide the A-SL to the body of the A10-RX.
Step 8
Replace all four corner 16mm screws, securing the A-SL to the A10-RX.

Step 9
The A-FLIP is now successfully installed and ready to use in any A10-RACK or Sound Devices SL-6.
