Support

SD-Utility v1.00

SD-Utility Installer for Windows SD-Utility Installer for Mac To communicate with the A10-RX on MacOS, download and install the CP210x USB to UART Bridge VCP Drivers from the Silicon Labs website.

A20-Remote

8-Series Firmware 8.04

Fixed Error message “Unable to record. SSD not formatted by [Scorpio][888][833].” no longer incorrectly appears and prevents recording.  Pressing the headphone knob in Headphone Preset and Bus Routing screens now correctly toggles the headphone monitor between the active bus or headphone preset and the current headphone selection.  SL-2 initialization improvements.

MixPre Firmware 7.13

Fixed MixPre no longer enters a state where there are level discrepancies between channels.  MixPre-3, MixPre-3M, MixPre-3 II, MixPre-6, MixPre-6M, and MixPre-6 II now provide a higher current on USB-A when the unit is powered via USB-C. USB-A provides up to 500 mA. Use a powered hub if your peripherals require more than 500 mA.

8-Series Firmware 8.03

Fixed Incorrect take numbers are no longer generated following the creation of a new daily folder. 8-Series no longer becomes unresponsive when exiting a Headphone Preset Routing menu using a PFL switch to navigate to the Channel screen and then again to the Meters screen.  Headphone Preset Routing menus now display changes to Com and […]

MixPre Firmware 7.12

Fixed MixPre-10T and -10 II no longer change trim levels after a power cycle when the extra channels and Aux inputs are in use. MixPre-10T and -10 II Aux input signal is no longer incorrectly routed to an output when assigned an isolated post-fade channel. MixPre-10T and -10 II timecode no longer resets to BNC […]