688 Firmware v2.11

  • Changes
    • The Circle Take (@) button on the CL-12 is locked out while in record and now always applies to Current Take.
    • Entering track names with no characters are not allowed. This is to prevent track name shifting issues.
  • Fixed
    • The REC button on the CL-12 now flashes during the record pending state.
    • The 688 Power LED no longer disappears whenever CL-12 & CL-6 are both connected to mixer.
    • Previously, when the SEL follows PFL feature was disabled, selecting an input channel’s PFL and SEL together, then pressing another SEL button would result in illumination of two SEL buttons on the CL-12. This has been fixed, so that when SEL follows PFL is disabled, the press of a single SEL button will replace selection of an earlier one.
    • Eliminated zipper noise when attenuating X1 and X2 track levels.
    • Eliminated stepping noise when attenuating L, R, X1, X2 output levels.
    • Reduced headphone monitor noise when adjusting headphone gain.
    • Fixed a rare issue where user settings could be lost over power cycles.
    • Fixed a rare issue where CL-12 power warning messages could appear at boot up.
    • Fixed an issue where changes to the CL-12’s L, R, X1, and X2 pot positions were not being read after a cold boot.
    • Fixed an issue where the CL-12 was showing internal tone 2 dB higher on its meters.
    • NP1 to DC switchover with an SL-6 connected is now fixed.