Firmware
MixPre Firmware v3.02
Fixed Noise floor no longer increases when phantom power is turned on and off. (All models) L/R Gain no longer changes when a USB controller is connected. (MixPre-10T, -10M) Stereo Out Gain no longer changes when a USB controller is connected. (MixPre-3, -3M, -6, -6M) MixPre no longer crashes when maximum note character limit (200 […]
Read The Full ArticleMixPre Firmware v3.01
Fixed For all models: The potential loss of recorded audio due to a failed automatic file split has been eliminated. For MixPre-3, -6, and -10T only: Media slow messages no longer appear when invalid or intermittent Aux In timecode is used with pre-roll.
Read The Full ArticleMixPre Firmware v3.00
New For all models: USB control from the Korg NanoKontrol Studio, Korg NanoKontrol2, Akai MidiMix, and Novation Launch Control XL USB control surfaces. Other USB control surfaces are not supported. Includes support for fader, trim, pan, low cut, reverb, solo, mute, track arm, monitor, transport control, LR output level, and user-programmable shortcut buttons. Note: available […]
Read The Full ArticleA10-TX Firmware v2.50
Firmware Version 2.50 – Released November 2018 New Support for A10 User Groups: allows for faster and easier setup with user-chosen names and frequency groups. Requires Mic2Wav v2.50 generated ALUG files to be loaded into the transmitter via a microSD card. Menu Lock: press and hold the left and right buttons simultaneously to lock the […]
Read The Full ArticleA10-RX Firmware v2.50
Firmware Version 2.50 – Released November 2018 New Support for A10 User Groups: allows for faster and easier setup with user-chosen names and frequency groups. Requires Mic2Wav v2.50 generated ALUG files to be loaded into the receiver: SuperSlot A10 receivers are loaded via an A10-RACK USB interface or via a 688/SL-6 using an SD card; […]
Read The Full Article